Installation Instructions

C
C
Page 5 of 7
ASSEMBLY INSTRUCTIONS (continued)
Connecting fixture to fixture
The LED strip lighting fixtures can be connected together in series using the plastic connector, or linking cord included
with this product. Maximum link up to 24pcs of 24" bar lights (#348-0101), or link up to 24pcs of 48" bar lights
(#348-0102).
8
The First Fixture
The Second Fixture
8. Remove the plastic plugs(C) from fixtures when you
require to use plastic connectors or linking cord.
9
A. Using plastic connector
Using plastic connectors to connect two more LED strip lighting fixtures: (Take two fixtures as example)
Turn off the power at fuse or circuit box.
The first fixture light has installed well as per single light installation.
Follow the step1~2 of single light installation for the second fixture light. ( do not remove three wire connectors from
three wires)
The First Fixture Light
The Second Fixture Plate
9. Plug one end of the plastic connector (DD) into the second fixture plate (A), and plug the other end of plastic
connector (DD) into the first fixture light.
DD
A
10
The First Fixture Light
The Second Fixture Plate
A
10. Marking the location on each side for the two anchors(AA) to secure fixture plate(A) on to the ceiling (do not mark
on the center of hole slot as it will not able to secure properly). Remove the fixture plate(A) and drill holes at the two
anchor location. Hammer the anchors(AA) into the hole tightly.
AA
BB
AA
11
The First Fixture Light
The Second Fixture Plate
A
11. Re-attach the second fixture plate (A) to ceiling and have the plastic connector plug into the second fixture plate,
and then secure it with dry wall screws (BB).
Follow the step 6~7 of single light installation for the second fixture light.
Turn on the power at fuse or circuit box.
Key hole slot