Installation Instructions

Page 4 of 7
ASSEMBLY INSTRUCTIONS (continued)
Wire Connector
Ceiling
Outlet Box
Key hole slot
5
A
A
B
BB
5. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Connect the fixture grounding wire (usually green insulation or bare wire) to the house grounding wire from the
power source.
Carefully tuck the wires back into the outlet box.
6
7
6. Plug 2 male connectors into 2 female connectors. Attach the aluminum plate to the fixture plate (A), and then secure
it with two set screws.
7. Attach the diffuser (B) back to the fixture plate (A) by sliding one side of the diffuser (B) into fixture plate (A) first, and
then press and push the other side of the diffuser (B) into the fixture plate (A).
Turn on the power at fuse or circuit box.
Set Screw
Aluminium Plate
LED Strip
Female Connector
Male Connector
Female Connector
Male Connector
Fixture Plate
Aluminium
Plate
Set Screw
Fixture Plate
A
Re-attach the fixture plate (A) to outlet box by inserting the two dry wall screw heads into the key hole slots on each
end of the fixture plate (A).Then slide the fixture plate (A) to left or right until the heads of the dry wall screw (BB) are
located into narrow ends of the key hole slot.Use a screwdriver (not included) to tighten the dry wall screws (BB).