Installation Instructions

For Ceiling Mounting:
Bulb Type ST Max.60W
( included)
Cable
Adapter
Cable
1. Cut off the cable near the bottom of the adapter. (See Figure 1)
2. Thread the cable through the canopy and two holes of the strain
relief in order.
3. Measure the desired length of the cable (A) from the canopy to
the top side of the fixture and leave an additional 9" of cable (B)
above the canopy (include the canopy). Then cut off the
unnecessary cable. (See Figure 2)
4. Adjust strain relief at 9" position from the top of the cord.
5. Mark the 3" of cord (C) from the top of the cord (B). Use a knife
to peel off the insulation of the cord (C) carefully to expose the
3 wires on the inside. (See Figure 2)
CAUTION: Too deep cutting may damage the insulation
layer of the three wires inside.
6. Peel off the 3 wires from the top about 3/8" long(D) to expose
the copper for wiring.
7. Thread the screws into the provided holes of the mounting
strap as shown. Thread the lock nuts onto the screws. Do
not tighten the lock nuts at this time.
8. Attach the mounting strap to the outlet box by using two
mounting screws.
9. Pull out the outlet wires and the house grounding wire from
the outlet box. Make wire connections using the wire nuts:
a. The black wire from the fixture to the black wire from the power source.
b. The white wire from the fixture to the white wire from the power source.
c. The green grounding wire from the fixture to the green grounding wire from power source.
Carefully put wires back into the outlet box.
10. Pull the cord ( A ) down slightly until the strain relief touches the hex nut of the canopy, then
fastening cable by screwing headless screw, using supplied flat head screwdriver.
Note: Adjusting the strain relief of the canopy can decrease or increase the length of cord
that is exposed.
11. Place the canopy over the outlet box and onto the screws. Adjust the screws until they protrude
out from the canopy 1/4”. Remove the canopy and secure the position of the screws by tightening
the lock nuts against the mounting strap. Place the canopy back into the screws, and secure it
with two ball nuts.
12. Install a bulb (included). See relamping label at socket area or packaging for maximum
allowed wattage.
13. Attach the glass shade to the glass bracket by threading set screws onto the glass notch. (Do
not over tighten.)
14. Turn on the power at the main fuse or circuit breaker box.
Outlet Box
Mounting Strap
Lock Nut
Mounting Screw
Screw
Wire Nut
A
C(3")
D(3/8")
B(9")
Figure.2
Figure.1
Strain Relief
Canopy
Ball Nut
Headless Screw
Fixture
Flat Head
Screwdriver
Set Screw
Notch
130829
Glass Shade
Glass Bracket