Installation Instructions

3/8"
Cable Length Adjustment (If in doubt, consult a qualified electrician)
Slide Pad
Spring
Adapter Holder
Adapter Cover
Set Screw
A
A
A
A
A
A
1"
1"
Adapter
Holder
Strain Relief
Strain Relief
Set Screw
1
3-b 3-c
3-a
4-a 4-b
2
Adapter Cover
Adapter Holder
Wire Nut
Adapter Cover
Adapter Holder
Cable
Cable
Slide Pad
Spring
INSTRUCTIONS
1. Remove the adapter cover from the adapter
holder by loosening the set screws (Figure 1).
Remove the slide pad and spring, and set
them aside.
2. Unscrew the wire nuts and separate the wires
(Figure 1).
3. Adjust the length of the cable:
a.) Measure the desired length of cable
and mark "A"; Slide adapter holder down
past "A". Fold cable down and slide strain
relief downward to loosen, then remove
Strain Relief from cable (Figure 3-a).
b.) Slide cable through side hole on Strain
Relief (Figure 3-b) until it is 1" above mark "A"; Loop
end of cable and slide through another hole on Strain Relief (3-c); Pull on both
ends of cable to tighten loop, making sure that Strain Relief is 1" above mark "A".
c.) Measure 2-3/4" from cable exiting Strain Relief, and cut off excess cable.
(Figure 4-a)
d.) Measure 2" down from end of cable; cut carefully around cable and peel
off insulation to reveal 3 inner wires (Figure 4-b).
CAUTION: Too deep cutting may damage the insulation layer of the three
wires inside.
e.) Measure 3/8" down from end of inner wires, and trim off insulation.
4. Make wire connections using wire nuts (see 2, above):
a.) Twist together the black wire from the cable and the black wire from the
adapter cover.
b.) Twist together the green wire from the cable and the green wire from the
adapter cover.
c.) Twist together the white wire from the cable and the white wire from the
adapter cover.
Carefully put the wires back into the adapter holder.
5. Pull the cable down until the strain relief hits the bottom of the adapter holder.
Then replace the spring and slide pad (5-a), and fasten the adapter cover to
the adapter holder (5-b) with the 2 set screws.
5-a 5-b
cut
trim
strip
2-3/4"
2"
130829