Installation Instructions

Page 3 of 5
201221
ASSEMBLY INSTRUCTIONS FOR TRACK MOUNTING (continued)
1
Set Screw
Adapter Cover
Adapter Holder
Slide Pad
Spring
1. Remove the adapter cover from
the adapter holder by loosening
the set screws. Remove the slide
pad and spring, and set them
aside.
2
Adapter Cover
Wire Connector
Adapter Holder
Cable
2. Unscrew the wire connectors and
separate the wires.
3. Adjust the length of the cable:
a.) Measure the desired length of
cable and mark "A"; Slide
adapter holder down past "A".
Remove strain relief from
cable.
b.) Weave the cable through the strain
relief as shown. Pull both ends of
the cable to tighten, making sure
that strain relief (EE) is 1" above
mark "A".
c.) Leave 2-3/4" of cable above strain
relief and then cut off the excess
cable.
Measure 2" down from end of
cable, cut carefully around cable
and peel off insulation to expose
3 internal wires
Note: Cutting too deep may
cut off the internal wires and
destroy the insulation surface of the internal wires.
Peel off the wires from the top about 3/8" to expose
the copper for wiring.
5. Pull down the cable until the strain
relief touches the bottom of the
adapter holder. Replace the spring
and slide pad, and fasten the
adapter cover to the adapter
holder with the two set screws.
5
Slide Pad
Spring
Adapter Holder
Adapter Cover
Set Screw
Cable
To Shorten the Cable of the Pendant (If in doubt, consult a qualified electrician)
4
Adapter Cover
Adapter Holder
Cable
Wire Connector
3a
A
A
Adapter
Holder
Strain Relief
3b
1"
A
A
Strain Relief
3c
3/8"
A
A
1"
Cut
2-3/4"
2"
4. Make wire connections using wire
connectors.
a. Connect the fixture black wire
from the cable to the black wire
from the adapter cover.
b. Connect the fixture white wire
from the cable to the white wire
from the adapter cover.
c.
Connect the fixture green
ground wire from the cable to
the green ground wire from the adapter cover.
Carefully tuck wires back into the adapter holder.
Strain
Relief