Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingLoft 1-Light Bronze Track Lighting Pendant

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-800-887-6326

Monday – Friday 9:00 a.m. – 5:00 p.m. CST

SKU Number: 349-5921

1-LIGHT TRACK LIGHTING PENDANT

Model Number: TKD5921BZ

PACKAGE CONTENTS

Max.60W Vintage Bulb

201221

HARDWARE CONTENTS

Bolt Nut

Canopy

Mounting Strap Unit

Mounting Screw

Wire Connector

Strain Relief

Flathead Screwdriver

Summary of content (5 pages)

PAGE 1
SKU Number: 349-5921 1-LIGHT TRACK LIGHTING PENDANT Model Number: TKD5921BZ Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-887-6326 Monday – Friday 9:00 a.m. – 5:00 p.m. CST PACKAGE CONTENTS A B C HARDWARE CONTENTS BB AA Mounting Strap Unit X1 CC EE DD Bolt Nut X2 Wire Connector X3 Mounting Screw X2 GG FF Strain Relief X1 HH Flathead Screwdriver X1 Canopy X1 Max.
PAGE 2
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING ● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). ● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
ASSEMBLY INSTRUCTIONS FOR TRACK MOUNTING (continued) To Shorten the Cable of the Pendant (If in doubt, consult a qualified electrician) 1. Remove the adapter cover from the adapter holder by loosening the set screws. Remove the slide pad and spring, and set them aside. 1 Set Screw 2. Unscrew the wire connectors and separate the wires. 2 Adapter Cover Adapter Cover Wire Connector Slide Pad Spring Adapter Holder Adapter Holder 3. Adjust the length of the cable: a.
PAGE 4
ASSEMBLY INSTRUCTIONS FOR CEILING MOUNTING Turn off the power at fuse or circuit box. 1. Attach mounting strap unit (AA) to 1 the outlet box using two mounting screws (BB). Adjust the length of long screws on the mounting strap unit (AA) if necessary. 3. Thread the cable through the canopy (GG) and two holes of the strain relief (EE). 2. Cut off the cable near the bottom of the adapter (A). A AA Long Screw 3 EE Cable 5. Pull down the cable slightly until the 5 strain relief (EE) touches the hex nut.
PAGE 5
The following parts are available for reorder if damaged or missing. Call our toll free at 1-800-887-6326. Spare Parts List: AA BB Mounting Strap Unit X1 CC Assembly Kit 4828MM (1 SET) Wire Connector X3 Mounting Screw X2 C DD EE Bolt Nut X2 FF Strain Relief X1 Glass Shade 9482C Flathead Screwdriver X1 HH GG Canopy X1 Vintage Bulb Max.60W 8058EB CARE AND MAINTENANCE ● To clean, turn off and wipe with a damp, non-abrasive cloth.