Installation Instructions

Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 3
SAFETY INFORMATION
PREPARATION
ASSEMBLY INSTRUCTIONS FOR SPOT LIGHT
CAUTION:
To reduce the risk of fire, electrical shock, or personal injury, do not touch or remove the spot light on the rail when
the light is on. Instead, turn off the electrical power. Unscrew the caps and to remove the spot light from the rail. Then
reinstall them back onto the desired positions of the rail.
1
B
A
A
1. Unscrews the caps(A) from
the rail adapter(B) of spot
light, and then turn the
movable part of rail
adapter(B) up.
Movable part
of Rail Adapter
2
B
A
B
A
Brass Clip
Ground Strip
Brass Strip
Rail
Ground Clip
2. Attach the rail adapter(B) of
the spot light onto the rail
(rail is sold separately).
Close back the movable
part of rail adapter(B) over
the rail, and then restore the
caps(A) back to the rail
adapter(B). Make certain that
the brass clips of the
adapter(B) are connected
properly with the brass strips.
Note: To ensure the fixture
works correctly, make sure
the connection between the
adapter and the rail is
correct. The ground strip
on the rail is always facing
to the ceiling.
Rail
Movable part
of Rail Adapter
Turn off the power at fuse or circuit box.