Installation Instructions

Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
● If you are unfamiliar with electrical installation, it is recommended to use a qualified electrician for your installation(s).
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product.
Tools Required for Assembly (not included): Slotted Screwdriver, Pliers, Ladder.
SAFETY INFORMATION
Page 2 of 3
201230
1. Insert three clips (AA) into the corresponding recesses indicated
with 3”,4”, 5” or 6” on the cover (A). Ensure that the clips are inserted
and stuck in place.
Note:
1. This cover is compatible with 3”, 4”, 5” and 6” recessed housing.
Please measure the opening of the housing which would be covered
before inserting the clips.
2. Only three clips need to be installed, the extra one is for spare use.
ASSEMBLY INSTRUCTIONS
3”
5”
6.6”
6.6”
6”
6”
6”
5”
5”
4”
4”
4”
3”
3”
6.6”
AA
A
1
Turn off the power at fuse or circuit box.
2
AA