Installation Instructions

PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 3
191025
ASSEMBLY INSTRUCTIONS
Turn on the power at fuse or circuit box.
1. Locate a suitable position
to place the fixture and
open in accordance to the
cut-hole dimensions.
A template is provided to
assist in properly locating
and cutting the hole.
Turn off the power at fuse or circuit box.
3. Insert hardwire box
through the mounting hole.
4. Connect and secure the
male / female connectors.
5. Push spring loaded clips on
the fixture upwards and push
the fixture into the ceiling.
The spring will hold the
fixture in place.
2. Connect electrical wires.
● Remove the appropriate
knock-out (s) to
accommodate the type
of electrical service to
be used.
● Insert electrical supply
cable through knock-out
into the hardwire box.
● Use quick connects push-in terminals, connect
ground wire of cable to ground wire on fixture.
Connect black wire of cable to black wire of fixture.
Connect white wire of cable to white wire of fixture.
● Place all wires and connections back in the hardwire
box and replace cover.
Note: Supply wire insulation must be rated for at least
90˚C.
1
4
Hardwire Box
Ground Wire
Power Supply
White Wire
Black Wire
2
5
3