Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingBlack LED Dual Mount Step Light

Page 1 of 4

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-800-887-6326

Monday – Friday 9:00 a.m. – 5:00 p.m. CST

Sku Number: 349-1827

349-1828

LED DUAL MOUNT STEP LIGHT

Model Number: RS2234

RS2238

PACKAGE CONTENTS

HARDWARE CONTENTS Note: Hardware not shown actual size.

Wire Connector

Mounting Screw

Allen Wrench

Summary of content (4 pages)

PAGE 1
Sku Number: 349-1827 349-1828 LED DUAL MOUNT STEP LIGHT Model Number: RS2234 RS2238 Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-887-6326 Monday – Friday 9:00 a.m. – 5:00 p.m. CST PACKAGE CONTENTS HARDWARE CONTENTS Note: Hardware not shown actual size.
PAGE 2
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING ● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). ● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
ASSEMBLY INSTRUCTIONS (continue) Note: This step light can be adjusted to vertical or horizonal mounting as follows: 3. Change the direction of the 3-A back plate from vertical to horizontal and then tighten the set screws. 1. Separate the face plate by using 1 the allen wrench (CC) to loosen the allen screw (B) of the face plate. Backplate B CC 2. Loosen the set screws on the back plate. 22 Back plate Assembly 3-B B BB The following parts are available for re-order if damaged or missing.
PAGE 4
CARE AND MAINTENANCE ● To clean, turn off and wipe with a damp, non-abrasive cloth. TROUBLESHOOTING PROBLEM POSSIBLE CAUSE The power is off. Check to ensure the power supply is on. The circuit breaker is off. Check to ensure the circuit breaker is in the on position. The fixture doesn't light up The fuse blown or circuit breaker tips when the light is turn on. CORRECTIVE ACTION There is a bad connection. Check to ensure proper wire connections are made. Contact a qualified electrician.