Installation Instructions

Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 4
SAFETY INFORMATION
ASSEMBLY INSTRUCTIONS
Turn off the power at fuse or circuit box.
1. Remove the face plate (A) by using
the allen wrench (CC) to loosen the
allen screw (B) of the face plate.
3. Attach the fixture to the
outlet box by using the
mounting screws (BB).
4. Attach the face plate on the
fixture, and tighten the
allen screw (B) by using
the allen wrench (CC).
1
2. Pull out the source wires from the
outlet box. Make wire connections
by using wire connectors (AA) as
follows:
● Connect the black wires from the
fixture to the black wire from the
power source.
● Connect the white wires from the
fixture to the white wire from the
power source.
● Connect the fixture ground wire to the house ground wire.
Carefully put the wires back into the outlet box.
2 4
3
B
B
CC
BB
CC
AA
Face plate A
Turn on the power at fuse or circuit box.