Installation Instructions

INSTALLATION INSTRUCTIONS FOR RECESSED LIGHTING FIXTURES

MODEL NUMBER 349-1739/1742/1768/1771

TO AVOID ELECTRICAL SHOCK OR FIRE, WHICH COULD BE INJURIOUS OR FATAL, PLEASE

MAKE SURE.....

TYPES OF INSTALLATION

*** To disconnect power at main fuse box before installing the fixture.

*** To check that the ground wire (bare or green insulated wire) is not connected to current carrying

supply wires.

*** That no bare wires are exposed outside of the connectors when connecting current carrying fixture

wires to current carrying house wires.

*** That the insulation on the fixture and house wires has not been damaged during installation and that

no rough or sharp edges of any surface are in contact with the wires.

*** The fixture supply wires are properly connected to the correct house supply wires.

*** Use only the type of light bulb specified with wattage no greater than specified on the max.wattage

label in the fixture.

*** Switch off the power when installing the light bulb in the fixture.

*** If you have any doubts about how to install this light fixture or it fails to operate properly, contact a

local licensed electrician.

This is the easiest way to install your recessed fixture. Before wall and ceiling covering materials are in

place, determine the location of the fixture and in accordance with local electrical standards, install the

wiring circuits.

Make sure that you have either an existing source of power or a way to supply it to area where this fixture will be

installed.

THESE FIXTURES MUST NOT BE BLANKETED WITH THERMAL INSULATION. KEEP INSULATION 3" AWAY

FROM HOUSING.

NEW CONSTRUCTION

EXISTING CEILING (RENOVATION)

NAIL IN TAB

BAR HANGER

PLASTER FRAME 349-1674

JOIST

Quantus Lighting

PAGE 1
INSTALLATION INSTRUCTIONS FOR RECESSED LIGHTING FIXTURES MODEL NUMBER 349-1739/1742/1768/1771 TO AVOID ELECTRICAL SHOCK OR FIRE, WHICH COULD BE INJURIOUS OR FATAL, PLEASE MAKE SURE..... *** To disconnect power at main fuse box before installing the fixture. *** To check that the ground wire (bare or green insulated wire) is not connected to current carrying supply wires.
PAGE 2
INSTALLING THE HOUSING NEW CONSTRUCTION You can use the two methods to install this fixture in new constructions Method NO. 1 --- Illustration-1 Purchase plaster frame accessory 349-1674. Position it between two joists with the lip surrounding the circular opening in the down position. The plaster frame should be level with the bottom of the joists with the lower edge of the lip 1/2" below that. Hammer a nail into both nail in tabs to secure to the joists.