Installation Instructions

1. Using 4.5“ template on
the box, mark the
openings and cut the
openings with a drywall
saw where you intend to
install the lights. (Fig.1)
2. Pull wiring through
hole cut out. Using the
wire-nut, connect the
incoming and outgoing
wires by matching white to
white, black to black and
green to ground wire and
twist on.
(Fig.2)
3. Lift the housing onto
the drywall. (Fig.3)
349-0003
349-0005
03/16
INSTALLATION:
SAFETY PRECAUTIONS:
RECESSED LIGHT
(FOR NON-INSULATED CEILING)
drywall saw
ceiling
(Fig.1)
4.5”
diameter hole
4. Push to lock the two
remodel clips to hold the can
against the ceiling. (Fig.4)
5. Using spring clips,
connect baffle to housing.
(Fig.5)
6. Install specified bulb type
and wattage (not included).
(Fig.5)
(Fig.4)
ceiling
housing
remodel
spring clip
junction box
housing
(Fig.5)
(Fig.2)
white
black
green ground
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED:
Blade
Screwdriver
Wire Cutters
Pliers Wrench
Saw
Wiring supplies
as required by
local electrical
code
QUESTIONS OR CONCERNS CONTACT PATRIOT AT: 1-800-267-4427 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T. or email to: [e-mail]
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CAUTION – RISK OF FIRE. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR.
4. CONNECT THE GROUND WIRE (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
5. DO NOT INSTALL INSULATION WITHIN 76 mm (3 inch) OF ANY PART OF THE LUMINAIRE.
NOTE: Product May Not Look Exactly As Shown In Figures.
baffle
bulb
(Fig.3)
ceiling
flex with
supply wires
housing