Installation Instructions
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 4
SAFETY INFORMATION
PREPARATION
ASSEMBLY INSTRUCTIONS
• All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
• Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means, do
not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
• If a dimmer control switch is used with this fixture, obtain professional advice to determine the correct type and
electrical rating required.
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
•
Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching
off circuit breaker).
• Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
Turn off the power at fuse or circuit box.
3-1
3. Install the silhouettes onto the frame.
a. Take a silhouette and place it onto
the frame with the hole in the frame
aligning the slot in the clip of the
silhouette, and then secure it with a
set screw.
b. Repeat with the other silhouettes.
c. There are labels attached on the
back of each silhouette. Please
follow the sequence to install the
silhouettes onto the frame.
d. Install the silhouettes to the location of silhouettes
to replace them.
4
3
P-U
P-U
P-U
P-U
P-U
P-U
P-U
P-W
P-W
P-W
P-W
P-W
P-W
P-W
P-R
P-R
P-R
P-R P-R
P-R
P-R
1. Attach the two long screws (BB)
to the mounting plate (AA), and
then secure them with two lock
nuts(EE).
4. Screw the threaded pipe into the
coupling of the main holder, and then
secure it with a washer and hex nut.
Then slide the tube assembly and
lower canopy down through the
threaded pipe and secure them with
a washer and hex nut.
Note: Make sure to keep the lower
canopy parallel to the hanger bar.
2. Attach the mounting plate(AA)
to the outlet box by using two
short mounting screws (CC).
1
AA
AA
CC
2
EE
BB
1