Installation Instructions

1. Measure the desired length of cord A exposing the fixture,
leave additional length of 13"cord B and cut off the
remaining cord.( see FIG.1)
2. Within the length of 3" cord C on the cord from the top, make
a mark E, use knife to slightly cut the cord.( see FIG.1)
Caution : Cutting too deep may cut three wires inside the
cord, and peel off the length of cord outside D
and leave 3 wires inside.
3. Peel off the length of 3 wires 3/8" from the top and expose
the cooper for wiring.( see FIG.1)
4. Unscrew the screws from the canopy.
5. Mount mounting strap securely to ceiling box with
2 mounting screws thru each slot in mounting
strap to ceiling box.
6. Thread the fixture wire through the canopy and strain
relief in order.
Note: Adjust the strain relief can decrease or
increase the length of cord exposing outside.
7. Make wire connections with wire nuts:
---Connect White Wire from the fixture to White Wire
from power source with a wire nut.
---Connect Black Wire from the fixture to Black Wire
from power source with a wire nut.
---Connect Green Grounding Wire from the fixture to Green
Grounding Wire from power source with a wire nut.
8. Pull the cord ( A ) down slightly until the strain
relief touches the hex nut. Attach the canopy to
the mounting strap by using 2 screws.
9.Install a bulb.(please do not exceed the maximum capacity,
which is recommended on the package.)
10.Turn on the power at fuse or circuit box.
Mounting Strap
Mounting Screw
Screw
Wire Nut
Strain Relief
Canopy
Cord (A)
Hex Nut
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING:
TO AVOID RISK OF ELECTRIC SHOCK, BE SURE TO SHUT
OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1.Before installing, consult local electrical codes for wiring requirements.
2.Please read the instructions carefully before you install this fixture. If you
are not familiar with installations, please consult the qualified electrician.
PD30103 PD30111 PD30112 PD30113
Installation Steps
Fixture Wire
A
C(3")
D(3/8")
B(13")
FIG.1