Installation Instructions

4.Connect the smooth to black
(power), the ribbed to white
(neutral) with the wire
connectors(CC) provided.
Connect the copper wire on
the light fixture to the mounting
plate(AA) by securing it with
the preinstalled grounding
screw, and then connect it to
the house grounding wire with
wire connector(CC). Tuck all
the wires into outlet box.
2.Attach the mounting
plate(AA) to outlet box with
mounting screws(BB).
A
AA
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse
(or switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to
contact any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause
serious injury or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified
electrician before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never
use a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding
means, do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to
proper grounding methods as required by the local electrical code in your area.
● If a dimmer control switch is used with this fixture, obtain professional advice to determine the correct type
and electrical rating required.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts
with package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
ASSEMBLY INSTRUCTIONS
Turn off the power at fuse or circuit box.
Page 2 of 3
1.Cut the “H” plastic buckles
with scissor when take down
the PE bags.
3.- Weave the fixture wires and
fixture grounding wire through
the chain(FF), collar(EE) and
the canopy(DD).
-Connect the chain(FF) to the
bottom loop(A) on the fixture
and the top loop on the
mounting plate(AA) using two
loop locks(GG).
-Thread the fixture wires and
fixture grounding wire through
the center of the mounting
plate(AA).
AA
DD
EE
GG
FF
A
PREPARATION
1
3
2
BB
AA
AA
4
CC