Installation Instructions

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, wire stripper.
Page 2 of 4
SAFETY INFORMATION
PREPARATION
Installation Steps (FOR PENDANT)
AA
AA
BB
C
DD
FF
CC
CC
JJ
A
B
C
D
Hex Nut
Cap
Washer
ASSEMBLY INSTRUCTIONS
Turn off the power at the main
fuse or circuit.
1. Attach threaded pipe (CC) to the
mounting strap (AA), then
secure it with a washer (FF) and
hex nut (DD).
1
5. Choose the length of the
chain (II) you need and cut,
then weave the fixture wires
and the fixture grounding
wire through the chain (II),
loop nut (HH), collar (KK)
and canopy (LL).
• All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
• Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means, do
not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
•
Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching
off circuit breaker).
• Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
2
3
2. Attach the mounting strap (AA)
to the outlet box by using two
mounting screws (BB).
3. Secure the top loop (JJ) to the
threaded pipe (CC).
4
5
LL
KK
HH
II
4. Attach the rod (B) and stem
(C) locked in the main
fixture (D), with the hex nut
and washer, then secure it
with a cap and loop (A).