Installation Instructions

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
352-5844
160415
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST)
3. READ AND SAVE THESE INSTRUCTIONS.
Mounting Strap (A)
Mounting Screw (B)
Green Grounding
Screw (C)
Wire Nut (D)
Hex Nut (E)
Washer (F)
Finial(H)
Threaded Pipe(G)
Loop Lock (I)
Chain (J)
Canopy (K)
Loop (L)
Rubber Pad (M)
1. Attach the threaded pipe to the mounting strap, and then
secure it with a washer and a hex nut.
2. Attach mounting strap to outlet box using two mounting
screws.
3. Thread the fixture wires and fixture grounding wire
through one of rubbers pad and one of loops, and then
secure two rubber pads and two loops onto two stems
of the fixture.
4. Connect the chain:
- Determine needed length of chain to achieve desired
fixture height. (To remove excess chain section, use
pliers to bend link open.)
- Weave the fixture wire and fixture grounding wire
through one chain and canopy.
5. Connect one end of one chain to the loop using a loop lock.
6. Connect the other end of the chain to the canopy loop using
the other loop lock.
7. Repeat step 5 and step 6 for hanging another chain.
Turn off the power at fuse or circuit box.
Installation Steps
Bulb Type A Max.100W
(not included)
Fixture Wire
Outlet Box
House Grounding Wire
Wire Nut (D)
Fixture Grounding Wire
Canopy (K)
Finial (H)
Mounting Strap (A)
Green Grounding Screw (C)
Mounting Screw (B)
Threaded Pipe(G)
Hex Nut (E)
Washer (F)
Chain (J)
Loop Lock (I)
Loop (L)
Stem
Rubber Pad (M)
Fixture
Socket
Glass Holder
Glass Shade
Socket Ring
Loop Lock (I)