Installation Instructions
ASSEMBLY INSTRUCTIONS
3
WHITE
BLACK (OR RED) WIRE
WHITE OR RIBBED
BLACK OR SMOOTH
FROM SUPPLY
FROM SUPPLY
FROM FIXTURE
FROM FIXTURE
STEP 3:
* Use Wire Connectors (supplied) to connect the
wires.
a) Ground Wire:
1. Wrap supply ground wire around green ground
screw on mounting bracket, no less than 2 in.
from the end of the wire. Tighten ground screw.
2. Connect fixture green ground wire to supply
ground wire with wire connector.
b) Supply Wire:
1. Connect the supply white wire to the white
fixture supply wire with wire connector.
2. Connect the supply black (or red) wire to the
black fixture supply wire with wire connector.
3. Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires
into the outlet box.
GROUND WIRE
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW
STEP 1:
A. Measure the distance between two keyholes on
the top of the Fixture Body (A). Use this distance
to identify corresponding mounting holes on the
Crossbar (AA) and thread Mounting Screws (EE)
into mounting holes.
B. Attach slots on the Crossbar (AA) to mounting
holes on outlet box with the head of Green Ground
Screw facing you. Secure the Crossbar (AA) with
Outlet Box Screws (DD). Tighten until snug with
screwdrivers.
C. Test fit the Fixture Body (A) to Mounting Screws
(EE) and adjust the length of Mounting Screws
(EE) so that the Fixture Body (A) flush against the
ceiling after installation. You may need to test fit
more than one time to achieve the correct length
of the Mounting Screw (EE).
Outlet Box Screws
AA
Outlet Box
Green Ground
Screw
EE
A
Keyhole
TOP VIEW OF
CEILING CANOPY
N
DD
STEP 2:
a. The lanyard is provided as a means to support the
fixture from the junction box while connecting the
electrical wires. This enables the fixture to hang
from the junction box and your hands are free to
make the wire connections.
b. Turn the button stop so it may be inserted into the
crossbar slot. Make sure the button stop is
completely inside the crossbar.
c. Slowly release the fixture to make sure it is
supported by the button stop.
d. Proceed to Step 3. Once wiring is complete, the
lanyard will push into the junction box when the
Ceiling Canopy is Attached to the Ceiling.
Crossbar Assembly
Slot
Lanyard
Button Stop
Ceiling Canopy