Installation Instructions

CARE AND MAINTENANCE
TROUBLESHOOTING
1) The light does not come on at all:
2) Fuse blows or circuit trips when light is turned on.
a) Make sure the wall switch and circuit breaker are on.
b) Make sure the wiring is correct.
a) Check for crossed wires, ensure wiring is correct.
If unable to fix any of the above issues, please consult a certified electrician.
• To clean, turn off and wipe with a damp, non-abrasive cloth.
Questions, problems, missing parts?
Before returning to your retailer, call our customer service at 1-800-645-3184,
Monday - , 7:00 a.m. -4:00 p.m., CST.Friday
7
ASSEMBLY INSTRUCTIONS
STEP 9:
a. Re-attach the ceiling canopy to the crossbar
assembly.
b. Then, attach the lock ball over the ceiling canopy.
c. Proceedtosteps7.8&9intheTrackLight
Assembly instructions above.
lock ball
Crossbar Assembly
WHITE
BLACK (OR RED) WIRE
WHITE
BLACK
FROM SUPPLY
FROM SUPPLY
FROM FIXTURE
FROM FIXTURE
STEP 8:
* Use Wire Connectors (supplied) to connect the
wires.
a) Ground Wire:
1. Wrap supply around
on mounting bracket, no less than 2 inches.
from the end of the wire. Tighten .
2. Connect fixture to
wire with wire connector.
b) Supply Wire:
1. Connect the to the
with wire connector.
2. Connect the wire to the
with wire connector.
3. Wrap each connection with approved electrical tape
and carefully stuff all of the connected wires into the
outlet box.
ground wire green ground
screw
ground screw
ground wire supply ground
supply white wire white fixture
supply wire
supply black (or red)
black fixture supply wire
GROUND WIRE
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW