Installation Instructions

ASSEMBLY INSTRUCTIONS
STEP 1:
a. Remove the Socket Assembly (F) from the
Ceiling Canopy by unscrewing Hex Nuts inside
of the Ceiling Canopy. Keep all separated parts
for the following steps.
FOR ISLAND LIGHT CEILING MOUNT
Spring Washers
Hex Nut
Flat Washer
Ceiling
Canopy
Rod
5
Lanyard
Outlet Box Screw
Outlet Box
STEP 3:
a. Remove lock ball from crossbar assembly.
b. Fit ceiling canopy over the nipple on crossbar
assembly and secure with lock ball.
: The ceiling canopy should be snug against
the ceiling and the lock ball.
- If not, adjust the length of the nipple on the
crossbar assembly by unscrewing the
preassembled hex nut.
- Then, screw the nipple in or out of the crossbar
until the desired length is achieved.
- Once the ceiling canopy is secure, remove the
lock ball and ceiling canopy and
Note
Proceed to
Step 4.
lock ball
Crossbar Assembly
Hex Nut and
Lock Washer
STEP 2:
a. Secure the crossbar (AA) to the outlet box (not
included) with outlet box screws.
b. Tighten until snug.
: The preassembled mounting nipple on the
crossbar should protrude outward.
Note
AA