Installation Instructions

ASSEMBLY INSTRUCTIONS
Outlet Box Screw
Outlet Box
STEP 2:
a. Remove lock ball from crossbar assembly.
b. Fit ceiling canopy over the nipple on crossbar
assembly and secure with lock ball.
: The ceiling canopy should be snug against
the ceiling and the lock ball.
- If not, adjust the length of the nipple on the
crossbar assembly by unscrewing the
preassembled hex nut.
- Then, screw the nipple in or out of the crossbar
until the desired length is achieved.
- Once the ceiling canopy is secure, remove the lock
ball and ceiling canopy and proceed to Step 3.
Note
lock ball
Crossbar Assembly
Hex Nut and
Lock Washer
STEP 1:
a. Secure the crossbar (AA) to the outlet box (not
included) with outlet box screws.
b. Tighten until snug.
: The preassembled mounting nipple on the
crossbar should protrude outward.
Note
Ceiling Canopy
STEP 3:
IMPORTANT:
DO NOT CUT WIRES
*
if you intend to use this as
an island light hanging fixture. Please go to
island light ceiling mount instructions on Page 5.
a. Cut wires 6" beyond canopy.
Extra wire length has been supplied for the island
light fixture.
Wire Strippers
6”
3
FOR TRACK LIGHT CEILING LIGHT
AA
STEP 4:
a. The lanyard is provided as a means to support
the fixture from the junction box while connecting
the electrical wires. This enables the fixture to
hang from the junction box and your hands are
free to make the wire connections.
b. Turn the button stop so it may be inserted into the
crossbar slot. Make sure the button stop is
completely inside the crossbar.
c. Slowly release the fixture to make sure it is
supported by the button stop.
d.
Once wiring is complete, the lanyard will push
into the junction box when the ceiling canopy is
attached to the ceiling.
Proceed to Step 5.
Crossbar Assembly
Button Stop
Lanyard
Slot