Installation Instructions

ASSEMBLY INSTRUCTIONS
3
Mounting
Screw
Hex Nut
Mounting Ball
Ceiling Canopy
STEP 2:
a. Remove mounting balls from the crossbar
assembly.
b. Fit the ceiling canopy to the crossbar assembly
and secure with mounting balls.
The ceiling canopy should be snug against
the ceiling and the mounting balls.
If not, adjust the length of the mounting screws on
the crossbar assembly by unscrewing the
preassembled hex nuts.
Then, screw the mounting screws in or out of the
crossbar until the desired length is achieved.
Once the ceiling canopy is secure, remove the
mounting balls and ceiling canopy and proceed to
Step 3.
Note:
?
?
?
STEP 4:
a. Re-attach the ceiling canopy of the Socket
Assembly to the crossbar assembly.
b. Secure with the previously removed mounting
balls.
Outlet Box
STEP 1:
a. Secure the crossbar (AA) to the outlet box (not
included) with outlet box screws (CC).
b. Tighten until snug.
The preassembled mounting screws on the
Crossbar should protrude outward.
Note:
Mounting
Screw
Hex Nut
Mounting Ball
Ceiling Canopy
WHITE
BLACK (OR RED) WIRE
WHITE
BLACK
FROM SUPPLY
FROM SUPPLY
FROM FIXTURE
FROM FIXTURE
STEP 3:
* Use Wire Connectors (supplied) to connect the
wires.
a) Ground Wire:
1. Wrap supply around
on mounting bracket, no less than 2 inches
from the end of the wire. Tighten .
2. Connect fixture to
wire with wire connector.
b) Supply Wire:
1. Connect the to the
with wire connector.
2. Connect the wire to the
with wire connector.
3. Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires
into the outlet box.
ground wire green ground
screw
ground screw
ground wire supply ground
supply white wire white
fixture supply wire
supply black (or red)
black fixture supply wire
GROUND WIRE
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW
AA
CC