Installation Instructions

4
ASSEMBLY INSTRUCTIONS
STEP 4:
a. Using wire cutters, cut the fixture wire leaving
approximately 10 inches of wire extending from
the Canopy.
b. On the fixture wire, remove 4 inches of the outer
sleeve.
c. Using wire strippers, strip each wire ½ inch from
the end.
Crossbar Assembly
Ceiling Canopy
Wire Clasp
WHITE
BLACK (OR RED) WIRE
WHITE
BLACK
FROM SUPPLY
FROM SUPPLY
FROM FIXTURE
FROM FIXTURE
STEP 5:
* Use Wire Connectors (supplied) to connect the
wires.
ground wire green
ground screw
ground screw
green ground wire canopy
ground wire supply ground wire
supply white wire white
fixture supply wire
supply black (or red)
black fixture supply wire
a) Ground Wire:
1.Wrap supply around
on mounting bracket, no less
than 2 in. from the end of the wire. Tighten
.
2.Connect fixture and
to with wire
connector
b) Supply Wire:
1.Connect the to the
with wire connector.
2.Connect the wire to the
with wire connector.
3.Wrap each connection with approved electrical
tape and carefully stuff all of the connected
wires into the outlet box.
GROUND WIRE
GREEN
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW
FROM CANOPY
GROUND WIRE
STEP 6:
a. Re-attach the ceiling canopy to the crossbar
assembly.
b. Secure with the previously removed ring.
c. Tighten until sung.
Outlet Box
Ceiling Canopy
Ring
Crossbar Assembly
STEP 7:
a. Insert bulbs (D) into fixture sockets.
b. Cover with bulb shields (E) only if using
halogen bulbs (D). Hand tighten until snug.
IMPORTANT:
Do not touch the bulb with bare hands as oil from
your skin can damage the bulb; use a soft cloth or
gloves.
A
D
E