Installation Instructions

ASSEMBLY INSTRUCTIONS
3
STEP 1:
Note:
Two people are recommended for this step.
a. Unscrew the preassembled ring on crossbar
assembly and detach it from ceiling canopy.
b. Attach the crossbar to the outlet box (not
included) with Outlet Box Screws (BB). Tighten
until sung.
Outlet Box
Ceiling Canopy
Wire Clasp
Button
Cable Clasp
Hex screw
Crossbar Assembly
Ceiling Canopy
Pull
Ring
Crossbar Assembly
STEP 2:
a. The recommended hanging height is 30 inches
from the bottom of the fixture to the top of the table
or island. To adjust the cable length, push and
hold the button on the underside of the canopy
and pull the cable to the desired length.
Recommended cable length, from the canopy to
fixture body, when mounting above a 30 inch high
table:
8 foot ceiling 22 inches
9 foot ceiling 34 inches
10 foot ceiling 46 inches
b. Once the correct height is achieved, pull an
additional 2 inches on length in order to set the
cable clasp.
c. Un-tighten the hex screw with the wrench.
Do not remove the hex screw.
d. Slide the Cable Clasp within two inches of the hex
nut inside of the Ceiling Canopy.
e. Re-tighten the hex screw with the allen wrench to
lock the Cable Clasp to the cable.
f. Lower cable until the Cable Clasp rest on the hex
nut.
:
The fixture wire should be slightly longer than the
cable. Do not cut the fixture wire and cable. This
will be done in .
allen
Note
step 3
Allen Wrench
Hex Nut
BB
Crossbar Assembly
Ceiling Canopy
STEP 3:
a. Confirm the desired hanging height. Refer to
if adjustments are needed.
b. Cut unneeded cable 4 inches from Cable Clasp
and discard.
c. Stuff cable into outlet box.
d. Hold canopy up to ceiling. Pull all wire thru wire
hole on the canopy. Leave 2 inches of slack.
e. Slide the wire clasp up to the wire hole in the
ceiling canopy.
:
Do not attached cable to house supply wires or
fixture wires.
step
2
WARNING
Wire Clasp