Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingRibbons Brushed Nickel/Polished Chrome 5-Light Pendant

SKU NUMBER: 351-9120

Pendant

MODEL NUMBER: MND3384A

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-800-645-3184

Monday - , 7:00 a.m. -4:00 p.m., CST.Friday

PACKAGE CONTENTS

REVISED 2017-04-26

PART

DESCRIPTION

QUANTITY

1pc

3pcs

2pcs

Wire Connector

Outlet Box Screw

Stock Part#

913450KIT

Fixture Body

Trimming (Pre-assembled to

Stem Assembly)

Stem Assembly

Bulb Shield

(

For Halogen Bulb Only)

Bulb

5pcs

I823SC

G13202BS

24 pcs

Allen Wrench

N/A

1pc

N/A

M13303ST

M13304TR

Summary of content (5 pages)

PAGE 1
SKU NUMBER: 351-9120 Pendant MODEL NUMBER: MND3384A REVISED 2017-04-26 PACKAGE CONTENTS DESCRIPTION PART QUANTITY Stock Part# AA Wire Connector 3 pcs BB Outlet Box Screw 2 pcs A Fixture Body Trimming (Pre-assembled to 1 pc B Stem Assembly) 913450KIT N/A 24 pcs M13304TR C Stem Assembly 24 pcs M13303ST D Bulb 5 pcs I823SC E Bulb Shield ( For Halogen Bulb Only) Allen Wrench 5 pcs G13202BS 1 pc N/A F AA BB A B C D E F Questions, problems, missing parts? Before returning t
PAGE 2
HARDWARE CONTENTS Note: Hardware not shown in actual size. AA Wire Connector x3 BB Outlet Box Screw x2 SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING: ● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). ● Be careful not to damage or cut the wire insulation (covering) during fixture installation.
PAGE 3
ASSEMBLY INSTRUCTIONS STEP 1: Outlet Box Note: Two people are recommended for this step. Crossbar Assembly BB Ceiling Canopy a. Unscrew the preassembled ring on crossbar assembly and detach it from ceiling canopy. b. Attach the crossbar to the outlet box (not included) with Outlet Box Screws (BB). Tighten until sung. Ring STEP 2: Cable Clasp a. The recommended hanging height is 30 inches from the bottom of the fixture to the top of the table or island.
PAGE 4
ASSEMBLY INSTRUCTIONS STEP 4: Crossbar Assembly a. Using wire cutters, cut the fixture wire leaving approximately 10 inches of wire extending from the Canopy. b. On the fixture wire, remove 4 inches of the outer sleeve. c. Using wire strippers, strip each wire ½ inch from the end. Wire Clasp Ceiling Canopy STEP 5: * Use Wire Connectors (supplied) to connect the wires. a) Ground Wire: 1.Wrap supply ground wire around green ground screw on mounting bracket, no less than 2 in. from the end of the wire.
PAGE 5
ASSEMBLY INSTRUCTIONS STEP 8: a. Adjust trimmings into position as shown in DRAWING A. b. Thread the Stem Assembly (C) into the fixture body for all stems. Hand tighten until snug. Fixture Body C DRAWING A Your installation is now complete! Restore electricity and save this sheet for future reference. CARE AND MAINTENANCE Wipe clean using soft, dry cloth or static duster. Always avoid using harsh chemicals and abrasives to clean fixture as they may damage the finish.