Installation Instructions

WARNING-RISH OF FIRE MOST DWEELINGS BUILT BEFORE 1985 HAVE
SUPPLY WIRE RATED 60ºC. CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALLING.
INSTALLATION INSTRUCTION AND TEMPLATE
FOR 4” REMODEL HOUSING
NOTE: IN AREAS WHERE EXCESSIVE CEILING VIBRATION CAN OCCUR. WE SUGGEST YOU USE A
#1/4-14 X ½” PAN HD SHEET METAL SCREW TO FURTHER LOCK THE SPRING CLIPS
AGAINS THE FIXTURE HOUSING. DRIVE THE SCREW THROUGH THE HOLE IN
THE SPRING CLIP AND INTO THE HOUSING SLOT.
1. USING TEMPLATE, SCRIBE CIRCLE ON CEILING IN DESIRED LOCATION.
2. ACCURATELY CUT HOLE IN CEILING.
3. PROVIDE ELECTRICAL SERVICE WITH FLEXIBLE CABLE ONLY. PASS CABLE THROUGH OPENING AND WIRE
FISXTURE IN ACCORDANCE WITH NEC OR YOUR LOCAL ELECTRICAL CODE.
4. WITH CLIPS SEATED PROPERLY IN CAN (FIG. 1), INSERT REMODEL HOUSING INTO CEILING,
JUNCTION BOX FIRST.
5. HOLD FIXTURE UP AGAINST CEILING AND PUSH CLIP THROUGH HOUSING SLOT (FIG. 2)
6. TO LOCK CLIP IN PLACE PUSH FLAT PORTION AGAINST SIDE OF CAN (FIG. 2).
7. TO RELEASE PULL DOWN ON CLIP (FIG. 3).
8. INSTALL TRIM.
TO INSTALL
(FIG. 1) (FIG. 2) (FIG. 3)
TO REMOVE
4.4”
FRONT