Assembly Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingAshtyn Matte Black & Charcoal Patina 3-Light Island Light

Please read and understand this entire manual before attempting to assemble, operate or install the product.

WARNING

● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or

switching off circuit breaker).

● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact

any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury

or death from electric shock.

CAUTION

● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).

Contact your municipal building department to learn about your local codes, permits and/or inspections.

● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician

before installation.

● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use

a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,

do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper

grounding methods as required by the local electrical code in your area.

PREPARATION

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with

package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,

install or operate the product. Contact customer service for replacement parts.

Tools Required for Assembly (not included): Slotted Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire

Cutters, Safety Glasses, Ladder, Wire Stripper.

Page 2 of 4

210605

ASSEMBLY INSTRUCTIONS

SAFETY INFORMATION

1. Attach mounting strap

unit(AA) to outlet box

by using two mounting

screws(BB).

Outlet Box

Note: The depth of

threaded pipe on the

mounting strap unit

may need to be

adjusted to properly

fit the fixture.

Turn off the power at the fuse or circiut box.

2. Secure the two rods

onto fixture(B) using

the threaded pipes.

Weave the fixture

wires through the

chain(FF) and

canopy unit(A).

Connect the two

chains(FF) to the

canopy unit(A) and

fixture loops with

four loop locks(EE).

Determine length of

chain(FF) needed

to achieve desired

fixture height.

(To remove excess

chain section, use

pliers to bend link

open.)

Fixture Loop

Rod