Installation Instructions

Turn off the power at fuse or circuit box.
1. Attach mounting strap unit (AA) to
outlet box by using two mounting
screws (BB).
Note: The depth of threaded
pipe on the mounting strap unit
may need to be adjusted to
properly fit the fixture.
EE
A
B
EE
FF
3
Top Loop
2. Attach the loops (B) and rubber
pad into the fixture (C).
2
B
C
Page 2 of 3
200605
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
ASSEMBLY INSTRUCTIONS
SAFETY INFORMATION
3. - Determine length of chains (FF)
needed to achieve desired fixture
height. (To remove excess chain
section, use pliers to bend link
open.)
- Weave the fixture wires and
fixture ground wire through
the two chains (FF) and the
plate (A).
- Connect the two chains (FF) to
the two loops (B) and the two
top loops using the four loop
locks (EE).
4. Connect the smooth wire from
the fixture (marked) to black
wire from the outlet box (power),
the ribbed wire from the fixture
(unmarked) to white wire from
the outlet box (neutral) with the
wire connectors (CC) provided.
Connect the copper wire on the light fixture to the
mounting strap unit (AA) by securing it with the green
ground screw, then connect it to the house ground wire
with wire connectors (CC).
Carefully put all the wires into outlet box.
AA
BB
1
AA
CC
4
Rubber Pad