Installation Instructions

Page 3 of 4
200608
ASSEMBLY INSTRUCTIONS (continued)
5. Pull out the source wires from
the outlet box. Make wire
connections using wire
connectors (CC) as follows:
• Connect the hot wire (black
insulation) from the fixture to
the black wire from the
power source.
• Connect the neutral wire
(white insulation) from
the fixture to the white wire from the power source.
• Attach the fixture ground wire (bare wire) to the
mounting plate unit (AA) with the green ground screw.
Then, depending on local code, connect it to the house
ground wire with the wire connector (CC).
Carefully put all of the wires back into the outlet box.
6. Secure the canopy (A) to the
mounting plate unit (AA) by
inserting the fixture mounting
screws, then secure it with
two bolt nuts.
7. Secure the glass shades (D)
onto the glass holders and
tighten the glass shades (D)
with the socket rings.
Install 4 X 60W medium base
bulbs (not included).
See relamping label at socket
area or packaging for
maximum wattage allowed.
Turn on the power at fuse or
circuit box.
4. Attach mounting plate unit
(AA) to the outlet box using
two mounting screws (BB).
Adjust the length of the
preinstalled fixture mounting
screws if necessary.
4
AA
Outlet Box
BB
3. Rod connections:
a. Thread the fixture wire from
the fixture through the lower
rod, then secure the lower
rod onto fixture using the
threaded pipe.
b. Thread the fixture wire
through the middle rod, then
secure the middle rod onto
the lower rod using the
threaded pipe.
c. Thread the fixture wire
through the upper rod, then
secure the upper rod onto
the middle rod using the
threaded pipe.
d.Thread the fixture wire
through the canopy (A), then
secure the canopy (A) onto
the upper rod using the
threaded pipe.
Note: The height can be adjusted to 57-3/4" by using the rods.
Use fewer rods if shorter height is desired.
Green Ground
Screw
AA
CC
5
5
AA
A
Bolt Nut
7
Socket Ring
Glass Holder
D
Medium base
bulb 60W
(not included)
3
Upper Rod (12")
Threaded Pipe
Threaded Pipe
Middle Rod (12")
Threaded Pipe
Middle Rod (6")
Lower Rod (6")
A