Installation Instructions

Please read and understand this entire manual before attempting to assemble, operate or install the product.

WARNING

● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or

switching off circuit breaker).

● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact

any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury

or death from electric shock.

CAUTION

● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).

Contact your municipal building department to learn about your local codes, permits and/or inspections.

● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician

before installation.

● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use

a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,

do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper

grounding methods as required by the local electrical code in your area.

PREPARATION

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with

package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,

install or operate the product. Contact customer service for replacement parts.

Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,

Safety Glasses, Ladder, Wire Stripper.

Page 2 of 4

200608

ASSEMBLY INSTRUCTIONS

Turn off the power at fuse or circuit box.

SAFETY INFORMATION

1. Unscrew the two bolt nuts.

Remove the mounting plate

unit (AA) from the canopy (A).

Bolt Nut

Tube

Rod

2. Screw the tube onto the main

fixture (C) and put the central

part (B) through the tube, then

screw the central part (B) onto

the main fixture (C). Finally fix

the central part (B) with rod.

Note: Make sure that the

tube and the central part

are align to main fixture

(See Fig.2a).