Installation Instructions

Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 4
200605
ASSEMBLY INSTRUCTIONS
Turn off the power at fuse or circuit box.
SAFETY INFORMATION
1. Attach mounting plate unit (AA)
to the outlet box using two
mounting screws (BB). Adjust
the length of the preinstalled
fixture mounting screws if
necessary.
1
AA
Outlet Box
BB
2. Rod connections:
a. Thread the fixture wire from
the fixture through the lower
rod, then secure the lower
rod onto fixture using the
threaded pipe.
b. Thread the fixture wire
through the middle rod, then
secure the middle rod onto
the lower rod using the
threaded pipe.
c. Thread the fixture wire
through the upper rod, then
secure the upper rod onto
the middle rod using the
threaded pipe.
d.Thread the fixture wire
through the canopy (A),
then secure the canopy (A)
onto the upper rod using
the threaded pipe.
Note: The height can be
adjusted to 41-1/2" by using the rods.
Use fewer rods if shorter height is desired.
2
Threaded Pipe
Threaded Pipe
Middle Rod (9-1/2”)
Middle Rod (9-1/2”)
Upper Rod (9-1/2”)
Threaded Pipe
Threaded Pipe
Lower Rod (9-1/2”)
A