Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingSpruce Black Walnut 4-Light Island Light

PREPAR

Turn off the power at fuse or circuit box.

1. Attach mounting strap unit (AA) to

outlet box by using two mounting

screws (BB).

Note: The depth of threaded

pipe on the mounting strap unit

may need to be adjusted to

properly fit the fixture.

Page 2 of 4

200609

Please read and understand this entire manual before attempting to assemble, operate or install the product.

WARNING

● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or

switching off circuit breaker).

● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact

any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury

or death from electric shock.

CAUTION

● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).

Contact your municipal building department to learn about your local codes, permits and/or inspections.

● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician

before installation.

● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use

a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,

do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper

grounding methods as required by the local electrical code in your area.

SAFETY INFORMATION

PREPARATION

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with

package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,

install or operate the product. Contact customer service for replacement parts.

Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,

Safety Glasses, Ladder, Wire Stripper.

ASSEMBLY INSTRUCTIONS

2. Rod connections:

a. Thread the fixture wire from

the fixture through the lower

rod, then secure the lower

rod onto fixture using the

threaded pipe.

b. Thread the fixture wire

through the middle rod, then

secure the middle rod onto

the lower rod using the

threaded pipe.

c. Thread the fixture wire

through the upper rod, then

secure the upper rod onto

the middle rod using the

threaded pipe.

d.Thread the fixture wire

through the loops (B), then

secure the loops (B) onto

the upper rod using the

threaded pipe.

Note: The height can be adjusted to 54-1/2" by

using the rods. Use fewer rods if shorter height is

desired.

Upper Rod (6”)

Threaded Pipe

Middle Rod (6”)

Threaded Pipe

Middle Rod (12”)

Lower Rod (12”)