Installation Instructions

9. Pull out the source wires from the back
plate. Make wire connections using wire
connectors as follows:
---The black wire from the back plate to
the smooth wire (marked) from the
plug cord.
---The white wire from the back plate to
the ridged wire (unmarked) from the
plug cord.
Carefully put the wires back into the
back plate.
10. Attach the back plate to the mounting
plate by inserting the headless screws,
then secure it with the ball nuts.
11. Attach the rod strap to the connected rod at the bottom, then secure it to the wall by using dry wall screws.
a) If the wall material is wood:
Attach the rod strap to the wall, thread the dry wall screws through the holes on rod strap, then secure them to the
wall.
b) If the wall material is cement:
Mark the holes where you want to place the rod strap on the wall. Drill the holes and insert the anchors into the
holes, then attach the rod strap to the wall, thread the dry wall screws through holes on rod strap, and then secure
them into the anchors.
12. Insert the plug into the wall receptacle.
Note:Remove the cover from the plug when the plug is used for the first time.
13. Swing the rocker arms and lamp head to reach desired positon to receive light.
181103
Page 3
Plug Cord
Back Plate
5/8"
5"
10"
Fig.2
Turn on the power at fuse or circuit box.
Spare Parts List:
The following parts are available for re-order if damaged or missing.
Mounting Screw (B)
Green Grounding
Screw (E)
Wire Connector (F)
Lock Nut (D)
Headless Screw (C)
Ball Nut (G)
Strain Relief (H)
Rod Strap (N)
Dry Wall Screw (O)
Anchor (L)
Hex Nut (J)
Washer (K)
Threaded Pipe (M)
Mounting Plate (A)
Mounting Hardware
5343MM (1 SET) for W0174
5344MM (1 SET) for W0175
Rod
3037RD (1 PC) for W0174
3038RD (1 PC) for W0175
Assembly Kit
5356MM (1 SET) for W0174
5357MM (1 SET) for W0175
Swivel (I)
A
B
C
A: 29˝
B: 10˝
C: 6-3/4˝