Installation Instructions

181103
Page 2
Turn on the power at fuse or circuit box.
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually bare wire) to the mounting plate with the green grounding screw then connect
it to the house grounding wire with a wire connector. If your outlet box does not have a house grounding wire, then wrap
the fixture grounding wire around the green grounding screw.
Carefully tuck the wires back into the outlet box.
4. Attach the back plate to the mounting plate by inserting the headless screws, then secure it with the ball nuts.
5. Swing the rocker arms and lamp head to reach desired positon to receive light.
1. Remove and discard the stopper from the
back plate.
2. Thread two headless screws through the
mounting plate, then secure them with
four lock nuts. Adjust the length of the
headless screws if necessary.
Note: Make sure that the headless screws
are lined up horizontally, in order to ensure
that the fixture will be level.
3. Unscrew and discard the green
grounding screw from the mounting
plate.
4. Place the mounting plate to a proper
position.
a) If the wall material is wood:
Attach the mounting plate to the wall,
then secure it with the dry wall screws
b) If the wall material is cement:
Mark the holes where you want to
place the mounting plate on the wall.
Drill the holes and insert the anchors
into the holes, then attach the
mounting plate to the wall, secure the
dry wall screws into the anchors.
5. Thread plug cord through the rods as
shown in order in Fig.1, swivel, threaded
pipe, the bottom hole of the back plate,
washer,and hex nut, then connect the
rods.
6. Secure the assembled rods to the back
plate by using the washer and hex nut.
7. Thread the plug cord through two holes of the strain relief. Pull the plug cord down until the strain relief touches the
back plate.
Note: Adjust the strain relief can decrease or increase the length of the exposed plug cord.
8. Cut any excess plug cord leaving 10 inches from the back plate. Slit the plug cord apart in 5 inches. Peel off insulation
of the two wires in 5/8 inch. (See Fig.2)
Assembly Instructions:
Turn off the power at fuse or
circuit box.
Option 2: (Plug-in Installation)
Stopper
Plug Cord
Strain Relief (H)
Fig.1
Rod
Rod Strap (N)
Bushing
LED Module
10W(Included)
Cover
Back Plate
Wire Connector (F)
Headless Screw (C)
Mounting Plate (A)
Dry Wall Screw (O)
Lock Nut (D)
Ball Nut (G)
Rocker Arm
Lamp Head
Anchor (L)
Swivel (I)
Hex Nut (J)
Washer (K)
Set Screw
Threaded
Pipe (M)
Anchor (L)
Plug