Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingDark Bronze Swing Arm Wall Light

Back Plate

Mounting Screw (B)

Green Grounding

Screw (E)

Wire Connector (F)

181103

Page 1

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

W0174 / W0175

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Lock Nut

(D)

Headless Screw (C)

Ball Nut (G)

1. Thread two headless screws through the mounting plate, then secure them with four lock nuts (two on each side of the

mounting plate). Adjust the length of the headless screws if necessary.

Note: Make sure that the headless screws are lined up horizontally, in order to ensure that the fixture will be level.

Attach the

mounting plate

to the outlet box by using two mounting screws.

Assembly Instructions:

Turn off the power at fuse or circuit box.

Ball Nut (G)

Rocker Arm

Lamp Head

Option 1: (Hard Wire Installation)

This fixture is dimmable with dimmable switch included,

please do not install it on the wall switch which have

dimming function. It can be mounted in two ways .

Strain Relief (H)

Rod Strap (N)

Dry Wall Screw (O)

Anchor (L)

Hex Nut (J)

Washer (K)

Threaded Pipe (M)

Outlet Box

Wire Connector (F)

Green Grounding

Screw (E)

Headless Screw (C)

Mounting Plate (A)

Mounting Screw (B)

Lock Nut

(D)

Fixture Grounding Wire

House Grounding Wire

Fixture Wire

LED Module

10W(Included)

Dimmable Switch

Mounting Plate (A)

Swivel (I)

Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before

installation, discharge yourself by touching a grounded bare metal surface to remove this

hazard. To avoid damage, do not touch the LED module.

Summary of content (3 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS W0174 / W0175 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before installation, discharge yourself by touching a grounded bare metal surface to remove this hazard.
PAGE 2
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows: ---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source. ---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source. ---Attach the fixture grounding wire (usually bare wire) to the mounting plate with the green grounding screw then connect it to the house grounding wire with a wire connector.
PAGE 3
9. Pull out the source wires from the back plate. Make wire connections using wire connectors as follows: ---The black wire from the back plate to the smooth wire (marked) from the plug cord. ---The white wire from the back plate to the ridged wire (unmarked) from the plug cord. Carefully put the wires back into the back plate. Fig.2 Plug Cord Back Plate 5" 5/8" 10. Attach the back plate to the mounting plate by inserting the headless screws, then secure it with the ball nuts. 10" 11.