Installation Instructions

b) For cement material:
Place the mounting plate to the outlet box and mark the target on the wall from the set hole for drilling two holes.
Remove the mounting plate from the outlet box. Thread the anchors into the holes, then attach the mounting plate
to the outlet box by using two mounting screws. Secure the dry wall screws through the set holes into the anchors.
4. Pull out the source wires from the outlet
box. Make wire connections using wire connectors as follow:
---Connect the hot wire (usually black insulation) from the fixture to the
black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the
white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green
grounding
screw, and then connect it to the house grounding wire with the wire connector.
Carefully put the wires back into the outlet box.
5. Attach the back plate to the mounting plate by inserting fixture mounting screws into the holes, then secure it with two
finials.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Spare
Parts
List:
Mounting Plate(A)
Wire Connector
(B)
Dry Wall Anchor(D) Green Grounding
Assembly Kit
Screw (C) Screw (E)
5762MM
(1
SET)
Fixture Mounting Finial (G) Pure Shell(H) Fishing Line(I) Lock Nut (J)
Screw (F)
A:42"
B:8
-
7/8"
C:5
-
1/2"
170925