Installation Instructions

1. Thread two headless screws through the mounting plate, then secure them with four lock nuts (two on each side of the

mounting plate). Adjust the length of the headless screws if necessary.

Note: Make sure that headless screws are lined up horizontally, in order to ensure that the fixture will be level.

2. Attach the mounting plate to the outlet box by using two mounting screws.

3. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:

---Connect the hot wire (black insulation) from the fixture to the black wires from the power source.

---Connect the neutral wire (white insulation) from the fixture to the white wires from the power source.

---Attach the fixture grounding wire (green insulation or bare wire) to the mounting plate with the green grounding screw,

and then connect it to the house grounding wire with the wire connector.

Carefully put the wires back into the outlet box.

4. Attach the back plate to the mounting plate by inserting the headless screw, then secure it with the two ball nuts.

5. Install the two bulbs (not included). Check relamping label at socket area or packaging for maximum allowed wattage.

Installation Steps

Turn off the power at fuse or circuit box

Turn on the power at fuse or circuit box

The following parts are available for re-order if damaged or missing.

Assembly Kit

5995 MM (1SET)

Spare Parts List:

Mounting Screw (B)

Wire Connector (F) Ball Nut (G)

Mounting Plate (A) Green Grounding

Screw (C)

Headless

Screw (D)

Lock Nut (E)

181109

A：14-1/4"

B：9-3/4"

C：8-1/4"