Manualshelf

Installation Instructions

ManualsBrandsPatriot Lighting ManualsFlush Mount LightsBurnaby Matte Brass 4 Light Semi-Flush Mount Ceiling Light
12
Hex Nut
Washer
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0112
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
151113
Green Grounding
Screw (E)
Fixture Mounting
Screw(D)
Mounting Screw (B)
Wire Nut (C)
Installation Steps
Lock Nut (F)
Ball Nut (G)
Canopy
Ball Nut (G)
Threaded Pipe
Mounting Plate (A)
House Grounding Wire
Fixture Grounding Wire
Wire Nut (C)
Fixture Mounting Screw (D)
Mounting Plate (A)
Green Grounding Screw (E)
Mounting Screw (B)
Lock nut (F)
Outlet Box
Bulb Type A Max.60W
(not included)
Socket
Coupling
Tube
Hex Nut (I)
Metal Pad (J)
Long Threaded Pipe (H)
Decorative Cup (K)
Finial (L)
Plastic Plate
Frosting
Bracket
Fabric Shade
Hex Nut (I)
Metal Pad (J)
Long Threaded Pipe (H)
Decorative Cup (K)
Finial (L)
1. Thread the fixture mounting screws through mounting plate,
and then secure them with two lock nuts. Adjust the length
of fixture mounting screws if necessary.
2. Attach mounting plate to the outlet box using two mounting
screws.
3.
Thread the fixture wire through the tube and the canopy.
4. Attach one end of the tube to the canopy, and the other end to the
threaded pipe of the fixture.
5. Attach the long threaded pipe to coupling, and then
secure the preinstalled washer and hex nut.
6. Attach the hex nut and the metal pad to the long
threaded pipe, slip the plastic plate and decorative
cup up through the long threaded pipe, and then
secure them with the finial.
NOTE: The depth of the lower hex nut and the
metal pad in long threaded pipe may need to be
adjusted to properly fit the plastic plate. The
plastic plate should be flatly laid on three
brackets, and the frosting of the plastic plate
should be faced down.
7. Install bulbs (not included). Check relamping
label at socket area or packaging for maximum
allowed wattage.

Summary of content (2 pages)