Installation Instructions

Mounting Screw
Headless Screw
Fixture Wire
Lock Nut
Mounting Plate
House Grounding Wire
Green Grounding Screw
Fixture Grounding Wire
Wire Nut
Outlet Box
070310
Back Plate
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
BL-VLU001
1. Thread two headless screws to the mounting plate, and secure them with four lock
nuts (two on each side of the mounting plate). Adjust the length of the headless
screws if necessary.
Note: Locate the two headless screws in horizontal line to ensure the fixture is in
proper position when the installation is done.
2. Attach the mounting plate to the outlet box by using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make
wire connections using the wire nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with the green grounding
screw. Then connect it to the house grounding wire with a wire nut.
Carefully tuck the wires back into the outlet box.
4. Attach the back plate to the mounting plate by inserting the headless screws, then
secure it with two bolt nuts.
5. Attach the glass shade onto the glass holder and secure it with the socket ring.
6. Install a bulb (not included). See relamping label at socket area or packaging for
maximum allowed wattage.
7. Turn on the power at the main fuse or circuit breaker box.
Bolt Nut
Glass Shade
Glass Holder
Socket Ring