Installation Instructions

1. Separate the gem bar (AA) from the fixture canopy (A) by removing

two flathead screws (DD).

3. Make all wire connections to appropriate wire. Secure with wire

nuts (CC) (provided). Connect the green or bare wire from the

fixture to the supply power source ground wire. Connect the black

wire from the fixture to the black (L) wire from supply power

source. Connect the white wire from the fixture to the white (N)

wire from supply power source. Do not mix wires. Pull on each

wire lead to make sure connections are secure. Make certain no

bare wires are exposed outside of wire connectors. Tuck all

connections neatly into the junction box.

2. Mount gem bar (AA) to the junction box (not included) using two

junction box screws (BB) (included).

Wiring – All wiring must take place inside junction box

(not included).

Caution: Make sure power is off at fuse or circuit breaker box. Check

power wires for damage or scrapes. If power supply wires are within

three inches of the LED driver, use wire suitable for at least 90°C

(194°F). Note: Most dwellings built before 1985 have supply wire rated

to 60°C. Consult a qualified electrician to ensure correct branch circuit

conductor before installing.

4. Mounting

Place fixture canopy (A) over the gem bar (AA) and align the

mounting holes on both sides of the canopy. Secure the fixture

using two flathead screws (DD).

Power to the fixture may now be restored.

ASSEMBLY INSTRUCTIONS

White (N) Power

Black (L) Power