Installation Instructions

2
SAFETY INFORMATION
PREPARATION
Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture.
Carefully remove the fixture from the carton, and check that all parts are included.
If parts are missing or damaged, do not attempt to assemble the product. Contact customer service at 1-800-873-2326
Monday - Friday, 8:00 am-4:30 pm Central Standard Time for replacement parts.
Estimated assembly time: 30 minutes.
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
• It is recommended that a qualified electrician perform all wiring. This fixture must be wired in accordance
with all national and local electrical codes.
• For installation in dry or damp residential applications.
• Read all safety precautions and installation instructions carefully before installing or servicing this fixture.
Failure to comply with these instructions could result in potentially fatal electric shock and/or property damage.
WARNING
• Do not handle any energized fixture or attempt to energize any fixture with wet hands or while standing on
a wet or damp surface or in water.
WARNING
• This product can expose you to lead, which is known to the State of California to cause cancer, birth defects or other
reproductive harm. For more informaton go to www.P65Warnings.ca.gov
CAUTION: This fixture is designed for use in a 120VAC, 60Hz fused circuit and can be used in conjunction with most
2-wire, TRIAC dimmers. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR. MINIMUM 90˚C SUPPLY CONDUCTORS.
• Disconnect electrical power before installing or servicing any part of this fixture.
• If power supply wires are within 7.6 cm (3 in) of the LED driver, use wire suitable for at least (90˚C) 194˚F.
• To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper grounding, there must be a separate ground wire
(green or copper) contact between this fixture and the ground connection of your main power supply panel.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules and CAN ICES-005. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiver antenna.
• Increase the separation between the equipment and receiver.
• Install the product onto on a circuit different from that to which the receiver is connected.
• Consult with the dealer or an experienced radio/TV technician for help.
Any modifications to this fixture may void the warranty and interfere with the safe operation of the luminaire.
Operation is subject to the following two conditions: (1) this devise may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the device.