Installation Instructions

LED Panel Light Installation Instructions
Thanks for using our products. Please read these installation instructions
before installing the luminaire, and keep them for future reference.
Technical Data
Warning
Installation Instructions
Luminaire must be installed, checked and repaired by an authorized electrician.
For proper operation, make sure to connect the luminaire to the proper voltage
and install it according to these instructions.
For safety purposes, cut off the power and allow the luminaire to cool before
installing or removing it.
Don’t install the panel light to an unstable ceiling or near combustible materials.
Cut off the power if there are any unexpected occurrences.
Do not alter or modify the luminaire or change any of the components.
Do not use the luminaire under conditions of direct sunlight, humidity, fog, rain,
corrosive gas, dust, or liquid.
Recessed In Plaster Or Grid Ceilings
Suspended Installation
Surface-Mounted Installation
120-277Vac
120-277Vac
120-277Vac
50-60Hz
50-60Hz
50-60Hz
40W
40W
50/70W
302x1213mm
603x603mm
603x1213mm
LED Panel Light
Product Name Dimensions Input Voltage Frequency
Power Consumption
Remove one side of the brackets.
3
Drill 4 small holes in the ceiling surface,
and then install the the expansion screws
and the brackets in the ceiling.
2
Assemble the mounting brackets.
1
Install the remaining side of the brackets.
6
Install the panel light into the brackets.
5
Connect the panel light to an incoming
power line.
4
321 4
321 4
For installation i n plaster ceilings,
cut an opening of the ap propriate
size, and then conne ct the panel
light to an incoming p ower line.
Rotate the panel lig ht by 45 degrees. Pass the panel throu gh the
ceiling surface.
Lay in the panel light on the ceiling
surface or grid.
Drill 4 small holes in the ceiling surface,
and then install the expansion screws
and the connectors.
Connect the cables to the earthquake
clips attached to the panel light.
Connect the other side of the cables to
the panel light.
Connect the panel light to an incoming
power line.
45
Wire Connections
LED Driver
L
N
Switch
LED
Panel
0-10VDC Dimmable
LED
Panel
LED Driver
Switch
0-10VDC Dimmable
L
N
0-10V
L N L
0-1 0VDC
LINE OUT
AC INPUT