Installation Instructions

ManualsBrandsPatriot Lighting ManualsLighting & Ceiling FansColor Changing Plug-In LED Tape Light

ASSEMBLY INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

PREPARATION

Please read and understand this entire manual before attempting to assemble,

operate or install the product. Please save this instruction manual.

WARNING

• Risk of electric shock: turn power off before servicing - see instructions.

• This luminaire must be installed in dry location only and in open fixtures only.

• CAUTION - To reduce the risk of fire, do not install more than 2 luminaires in

compartment smaller than 12 inches by 12 inches by 12 inches.

• Use only insulated staples or plastics ties to secure cord;

• Route and secure cords so that they will not be pinched or damaged when the

cabinet is pushed to the wall;

• Position the portable cabinet light with respect to the cabinet so the lamp

replacement markings are able to be read during relamping.

• Not intended for recessed installation in ceilings, or recessed installation in soffits.

• The National Electrical Code (NEC) does not permit cords to be concealed

where damage to insulation may go unnoticed. To prevent fire danger, do not run

cord behind walls, ceilings, soffits, or cabinets where it may be inaccessible for

examination. Cords should be visually examined periodically and immediately

replaced when any damage is noted.

• This product is not a toy. Do not store or leave this luminaire in a location

accessible to young children.

• Do not install this luminaire in a heat-producing appliances.

•

Risk of fire hazard, only connect a maximum of a TOTAL length to the following Adapter.

CAUTION

Before beginning assembly, installation or operation of product, make sure all parts

are present. Compare parts with package contents list and diagram on previous page.

If any part is missing or damaged, do not attempt to assemble, install or operate the

product. Contact customer service for replacement parts.

Tools Required for Assembly (not included): Phillips Screwdriver, Scissors

Menards sku #

Adapter Model

Maximum TOTAL length

346-0607

TP02-120100U

60 inch (5 x 12’’ tape)

• Ensure NOT to exceed the above maximum (loading) total length before

adding any accessories.

• If this unit is installed in an outdoor location, the transformer (driver) must

be installed using an outdoor electrical box and fully covered by an outdoor

in use cover certified for wet location.

•

Remove batteries to prevent product damage when the product is not used for long period of time.

• Batteries must be insert in correct position.

• Do not throw batteries into fire or expose them to excess heat.

• This luminaire includes an adapter that is only designed for use with this luminaire.

1. MEASURE – and lay-out the installation prior to removing the backing exposing the

adhesive. Ensure mounting surface is clean and free of any debris or residue.

2. CONNECT - Ensure the plug is polarized.

Connect the tape (A) and cord connectors (DD, Optional).

3. MOUNT – Remove the backing to expose adhesive tape. Place in the desired location.

To obtain optimum adhesion, ensure the surface is clean. Mounting clips (EE) are also

provided for extra support with screws (FF).

4. CONNECT – Connect the tape (A) to the dimmer (BB). Then connect the dimmer(BB) to

the transformer (AA) and plug in. The dimmer (BB) must be placed in a dry location. Use

the two screws (FF) to hold the dimmer (BB) in place.

Now your remote control(CC) is ready to use. To use the RGB Remote Control (CC) make

sure you are no more than 8 meters away from dimmer (BB). The RGB Remote Control

(CC) is capable of many color changing effects. (flashing, strobe flash, fade, smooth etc.)

12V

FLASH

OFF

FADE

SMOOTH

STROBE

WR G

12V

POLARIZED