Installation Instructions

2
3
IMPORTANT SAFETY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
PREPARATION
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
Please save this instruction manual.
WARNING
• Turn off electricity at main fuse box (or circuit breaker box) before beginning
installation by removing fuse (or switching off circuit breaker).
• Be careful not to damage or cut the wire insulation (covering) during fixture
installation. Do not permit wires to contact any surface having a sharp edge.
To do so may damage or cut the wire insulation, which could cause serious
injury or death from electric shock.
• This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product and
the hazards involved.
• Connect the ground wires (bare copper or green) from your fixture to the ground
wire (bare copper or green) or ground screw in the electrical box.
CAUTION
• All electrical connections must be in agreement with local codes, ordinances or
the national electric code (NEC). Contact your municipal building department to
learn about your local codes, permits and/or inspections.
• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC.
Consult a qualified electrician before installation.
• Do not connect this fixture to an electrical system that does not provide a means for
equipment grounding. Never use a fixture in a two-wire system that is not grounded.
If you are not sure your lighting system has a grounding means, do not attempt to
install this fixture. Contact a qualified, licensed electrician for information with regards
to proper grounding methods as required by the local electrical code in your area.
• If a dimmer control switch is used with this fixture, obtain professional advice to
determine the correct type and electrical rating required.
Before beginning assembly, installation or operation of product, make sure all parts
are present. Compare parts with package contents list and diagram on previous page.
If any part is missing or damaged, do not attempt to assemble, install or operate the
product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers,
Electrical Tape, Wire Cutters, Safety Glasses, Ladder, Wire Stripper
Electrical
Box
CC
BB
BB
A
AA
1. Feed power cords from the electrical box
through the center hole of the mounting
bracket (BB). Mount the mounting bracket
(BB) to electrical box using electrical box
screws (CC).
2. Use the suspending wire to hang the
fixture as shown for wiring connection.
GND
Suspending
Wire
A
A
3. Connect the ground wires (bare copper
or green) from your fixture (A) to the
ground wire (bare copper or green) or
ground screw in the electrical box.
Connect the black wire from the fixture (A)
to the black wire in the electrical box and
connect the white wire from the fixture (A)
to the white wire in the electrical box.
IMPORTANT: Once connections of
wires are completed, carefully tuck
wires and wire nuts (AA) into the
electrical box making sure no bare wire
is visible at the wire nuts (AA).
House
Supply
Ground
Wire
Fixture
Ground
wire
Black
White
4. Attach fixture to mounting bracket (BB)
by tightening the 2 screws.
5. Adjust the height of the fixture (A) by
pushing the button.
Screw
dimmable
This LED light is suitable to be dimmed by
Leviton# 742-6672-HLW, 722-6674-PDW MAX 150 W,
Lutron # SCL-153PH-WH, DVWCL-153PH-WH,TGCL-153PH-WH MAX 150 W,
Eaton # SAL06-W-K MAX 150 W.
The MAX rated wattage of this model is 36 W