Installation Instructions

2
3
DD
ASSEMBLY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
PREPARATION
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
Please save this instruction manual.
WARNING
• Turn off electricity at main fuse box (or circuit breaker box) before beginning
installation by removing fuse (or switching off circuit breaker).
• Be careful not to damage or cut the wire insulation (covering) during fixture
installation. Do not permit wires to contact any surface having a sharp edge.
To do so may damage or cut the wire insulation, which could cause serious
injury or death from electric shock.
• This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product and
the hazards involved.
• Connect the ground wires (bare copper or green) from your fixture to the ground
wire (bare copper or green) or ground screw in the electrical box.
CAUTION
• All electrical connections must be in agreement with local codes, ordinances or
the national electric code (NEC). Contact your municipal building department to
learn about your local codes, permits and/or inspections.
• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC.
Consult a qualified electrician before installation.
• Do not connect this fixture to an electrical system that does not provide a means for
equipment grounding. Never use a fixture in a two-wire system that is not grounded.
If you are not sure your lighting system has a grounding means, do not attempt to
install this fixture. Contact a qualified, licensed electrician for information with regards
to proper grounding methods as required by the local electrical code in your area.
• If a dimmer control switch is used with this fixture, obtain professional advice to
determine the correct type and electrical rating required.
Before beginning assembly, installation or operation of product, make sure all parts
are present. Compare parts with package contents list and diagram on previous page.
If any part is missing or damaged, do not attempt to assemble, install or operate the
product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers,
Electrical Tape, Wire Cutters, Safety Glasses, Ladder, Wire Stripper
2. Connect the ground wires (bare copper or
green) from your fixture (A) to the ground wire
(bare copper or green) or ground screw in the
electrical box. Connect black wire from fixture
(A) to black wire in electrical box and connect
the white wire from fixture (A) to white wire in
electrical box.
EE
FF
A
B
4. Remove spinner nut (GG) from socket.
Position glass (B) on lamp and secure with
spinner nut (GG). Install proper bulb (HH)
type and wattage
AA
AA
White
Black
House supply
Ground wire
Fixture
Ground wire
3. Once connections of wires are completed,
carefully tuck wires and wire nuts (AA) into
the electrical box making sure no bare wire
(on the black and white) is visible at the wire
nuts (AA). Secure the pan to the nipple
tightening by star washer (DD) and hex
nut (EE). Screw the finial (FF) to the nipple.
GG
HH
Electrical
Box
CC
BB
1. Attach the mounting bracket (BB) to the
electrical box using electrical box screws (CC).
Attach the nipple to the mounting bracket (BB)
and adjust until it will clear the canopy when
assembled. Lock the nipple in the correct
position using the hex nut.
Nipple
Nipple
Hex nut