Installation Instructions

3
ASSEMBLY INSTRUCTIONS
4. To attach chain loop to light fixture, use a
screwdriver and wrench to open and close
chain loop. Ensure to close the opening.
Weave the power cord and ground wire
through the links in the chain (EE).
5. Loosen the nut on the upper connector
and slide it down the chain (EE) towards the
lower connector. Slide the canopy (DD)
down the chain (EE) towards the lower
connector. Feed the wire through nut,
canopy (DD), the upper connector and onto
the nipple. Tighten the upper connector onto
the nipple. Spread the other end of the chain
(EE) open and fasten to the upper connector.
Ensure the opening is closed.
Power
Cord
B
A
B
Electrical
Box
2. Determine the height that you would
like to hang your fixture. Trim the cord and
chain. Allow 10” of extra wiring for the
electrical box connections.
CC
BB
BB
EE
EE
DD
3. Loosen the upper connector from
nipple. Attach the mounting bracket (BB)
to the electrical box using electrical box
screws (CC). Attach the nipple to the
mounting bracket (BB) and adjust until it will
clear the canopy (DD) when assembled
(Place the canopy (DD) over the nipple
and tighten the upper connector onto
the nipple until snug. The upper connector
should hold the canopy (DD) snug to the
ceiling). Lock the nipple in the correct
position using the hex nut.
Nipple
Nipple
Nipple
Upper connector
Upper connector
Hex nut
Nut
1. Tighten the loop (B) to the stem on
the fixture (A). Install the decorative
frames (C) with the star washers and
nuts.
C
Nut
Star
Washer