Installation Instructions

3
ASSEMBLY INSTRUCTIONS
4. To attach chain loop to light fixture, use a
screwdriver and wrench to open and close
chain loop. Ensure to close the opening.
Weave the power cord and ground wire
through the links in the chain (EE).
Power
Cord
B
Electrical
Box
2. Determine the height that you would
like to hang your fixture. Trim the cord and
chain. Allow 10” of extra wiring for the
electrical box connections.
CC
BB
BB
EE
3. Loosen the upper connector from
stud. Attach the mounting bracket (BB)
to the electrical box using electrical box
screws (CC). Attach the stud to the
mounting bracket (BB) and adjust until it will
clear the canopy (DD) when assembled
(Place the canopy (DD) over the stud
and tighten the upper connector onto
the stud until snug. The upper connector
should hold the canopy (DD) snug to the
ceiling). Lock the stud in the correct
position using the hex nut.
Stud
Stud
Stud
Upper connector
Hex nut
1. Screw the center rod (C) to the fixture (A).
Tighten the loop (B) to the center rod (C).
A
B
C
EE
DD
5. Loosen the nut on the upper connector
and slide it down the chain (EE) towards the
lower connector. Slide the canopy (DD) down
the chain (EE) towards the lower connector.
Feed the wire through nut, canopy (DD), the
upper connector and onto the stud.
Tighten the upper connector onto the stud.
Spread the other end of the chain (EE) open
and fasten to the upper connector. Ensure
the opening is closed.
Upper connector
Nut