Installation Instructions

ManualsBrandsPatriot Lighting ManualsChandeliersGrenadier Oil-Rubbed Bronze 6-Light Chandelier

SKU Number: 351-8682

6-Light Chandelier

Model Number: ICH686B06ORB-M

Questions, problems, missing parts?

Before returning to your retailer, call our customer service

at 1-800-267-4427 Monday – Friday 8:00 a.m. – 5:00 p.m. EST

PACKAGE CONTENTS

HARDWARE CONTENTS Note: Hardware not shown actual size.

06-20

Wire Nut

x 3

Electrical Box Screw

x 2

Canopy

x 1

Chain

x 1

Spinner Nut

x 6

Mounting Bracket

x 1

Summary of content (4 pages)

PAGE 1
SKU Number: 351-8682 6-Light Chandelier Model Number: ICH686B06ORB-M Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-267-4427 Monday – Friday 8:00 a.m. – 5:00 p.m. EST PACKAGE CONTENTS B C D A HARDWARE CONTENTS Note: Hardware not shown actual size.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS Please read and understand this entire manual before attempting to assemble, operate or install the product. Please save this instruction manual. WARNING • Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). • Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
4 5 ASSEMBLY INSTRUCTIONS (continued) CARE AND MAINTENANCE ASSEMBLY INSTRUCTIONS 6. Connect the ground wires (bare copper or green) from your fixture to the ground wire (bare copper or green) or ground screw in the electrical box. Connect the black wire (or wire marked “SPT-1”) from the fixture to the black wire in the electrical box and connect the white wire (or the wire with ribbed side) from the fixture to the white wire in the electrical box. Use supplied wire nuts (AA) for all wire connections.
PAGE 4
3 ASSEMBLY INSTRUCTIONS 1. Screw the center rod (C) to the fixture (A). Tighten the loop (B) to the center rod (C). Electrical Box BB B Stud Hex nut CC C 4. To attach chain loop to light fixture, use a screwdriver and wrench to open and close chain loop. Ensure to close the opening. Weave the power cord and ground wire through the links in the chain (EE). Power Cord A 2. Determine the height that you would like to hang your fixture. Trim the cord and chain.