Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingCleavon Chrome 4-Light Island Light

IMPORTANT SAFETY INSTRUCTIONS

ASSEMBLY INSTRUCTIONS

PREPARATION

Please read and understand this entire manual before attempting to assemble,

operate or install the product.

Please save this instruction manual.

WARNING

• Turn off electricity at main fuse box (or circuit breaker box) before beginning

installation by removing fuse (or switching off circuit breaker).

• Be careful not to damage or cut the wire insulation (covering) during fixture

installation. Do not permit wires to contact any surface having a sharp edge.

To do so may damage or cut the wire insulation, which could cause serious

injury or death from electric shock.

• This product must be installed in accordance with the applicable installation

code by a person familiar with the construction and operation of the product and

the hazards involved.

• Connect the ground wires (bare copper or green) from your fixture to the ground

wire (bare copper or green) or ground screw in the electrical box.

CAUTION

• All electrical connections must be in agreement with local codes, ordinances or

the national electric code (NEC). Contact your municipal building department to

learn about your local codes, permits and/or inspections.

• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC.

Consult a qualified electrician before installation.

• Do not connect this fixture to an electrical system that does not provide a means for

equipment grounding. Never use a fixture in a two-wire system that is not grounded.

If you are not sure your lighting system has a grounding means, do not attempt to

install this fixture. Contact a qualified, licensed electrician for information with regards

to proper grounding methods as required by the local electrical code in your area.

• If a dimmer control switch is used with this fixture, obtain professional advice to

determine the correct type and electrical rating required.

Before beginning assembly, installation or operation of product, make sure all parts

are present. Compare parts with package contents list and diagram on previous page.

If any part is missing or damaged, do not attempt to assemble, install or operate the

product. Contact customer service for replacement parts.

Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers,

Electrical Tape, Wire Cutters, Safety Glasses, Ladder, Wire Stripper

1. Install the length of rod (HH) that is

required by threading wire through the rod

(HH) and securing it to the fixture (A).

Install swivel to the rod (HH), ensuring that

the sleeve is at the swivel.

2. Tighten the hex nut and washer to the

stem on the canopy (GG).

4. Connect the ground wires (bare copper or

green) from your fixture to the ground wire

(bare copper or green) or ground screw in the

electrical box. Connect black wires from fixture

to black wire in electrical box and connect the

white wires from fixture to white wire in

electrical box. Use supplied wire nuts (AA) for

all wire connections.

3. Attach stud to mounting bracket (BB).

Adjust so it will clear hole in back of fixture

and then lock stud in place with star washer

and hex nut. Attach mounting bracket (BB) to

electrical box with electrical box screws (CC).

5. Once connections of wires are completed,

carefully tuck wires and wire nuts (AA) into the

electrical box making sure no bare wire (on the

black and white) is visible at the wire nuts (AA).

6. Secure the pan to the stud tightening by

star washer (DD) and hex nut (FF). Screw the

finial (EE) to the stud.

7. Install the specified bulb type and wattage

(not included).

Hex

Nut

Star

Washer

Sleeve

Swivel

Electrical

Box

Hex nut

Stud

White

Black

House supply

Ground wire

Fixture

Ground wire

Stud

Bulb